■ Marinas on plastic pontoons ■

Plastic pontoons are made by rot molding (seamless mold).  Pontoons are resistant to ice pressure, ultraviolet light, salted water and petroleum products.  Plastic pontoons can be either hollow or filled with foam polyester.

Wood and construction: all wood used is (Impregnated vacuum pressure method, class: HC4), load bearing beams are 50 x150 and 75 x 200 mm.  Elements on plastic pontoons are fastened with 5mm thick edges.  Deck wood is (strength C16 according to EN 338 standard) milled from sides (non slippery, if one side is damaged the other side can be used).  Wooden elements connecting pontoons are of standard sizes.  For plastic pontoons they are 2 x 4 m,  2 x 6 m, 2,4 x 4 m, 2,4 x 6 meters.

Metal elements: edges, anchor chains, staples, ladder railings, hinges and bolts are hot dipped galvanized.  Screws holding the deck wood are coated with special for impregnated wood.

Anchoring.  On the waterfront pontoons and marinas are fastened by chains to the coast elements, water side is anchored.  Various concrete anchors used to securely position the pontoons. Pontoons are connected with each over using chains. Anchors in shallow waters up to 2 meters are covered with ground.

Access bridge is attached to the fastening elements on the shore.  The other side of the bridge has either wheels or hinges.  It is laid on or attached to the standard element.  Main or standard element is fixed by concrete anchors. Anchors and pontoons are connected by hot dipped galvanized chain. 

All manufacturing is certified and have declarations of conformity.
ISO 9001:2015, ISO 14001:2015

      Technical specifications in PDF format:
Swimming bridge on 400 L capacity plastic pontoons.
Swimming bridge on 200 L capacity plastic pontoons.
Marinas on 450 liters capacity plastic pontoons.

■ Marinas on plastic pontoons ■